Table for PDQ 36

Post here if you want to discuss a topic specific to the PDQ Capella.
Post Reply
Old PDQ Message Board
Site Admin
Posts: 522
Joined: Sun Apr 25, 2004 11:08 pm

Table for PDQ 36

by Old PDQ Message Board » Mon Apr 26, 2004 5:04 am

Table for PDQ 36

Posted by Jim Hughes on January 25, 2002 at 13:29:00:

Has anyone rigged a table for in front of the bench (which is a part of the
dinghy davits) for the copit of a PDQ 36?

Follow Ups:

Re: Table for PDQ 36 Harriet Eisen 16:23:07 01/25/02 (0)

--------
Re: Table for PDQ 36

Posted by Harriet Eisen on January 25, 2002 at 16:23:00:
In Reply to: Table for PDQ 36 posted by Jim Hughes on January 25, 2002 at
13:29:00:


We rigged a table for our cockpit, but we don't have the newer bench/davit
combo. We installed a pedestal base in the floor at the aft starboard corner of
the cockpit. The pole fits into the base, and curves to run parallel to the
cockpit floor, kind of like an upside down L. For a better "picture", check with
Lewis Marine at http://www.lewismarine.com, page 764 of their catalog, figure 9341. The
table top, which we store in the "garage" (aft port cabin), slides onto the
pedestal and locks in place. I realize that this may or may not work for you,
but it might give you some ideas as starting points. Good luck

Harriet Eisen
s/v Perseverance
Hull 26

Post Reply