Propshaft pitting

Post here if you want to discuss a topic specific to the MV/32, MV/34, and MV/41.
Post Reply
Allezcat
admiral
admiral
Posts: 272
Joined: Fri May 07, 2004 9:29 pm
Location: Punta Gorda, Fl 33955

Propshaft pitting

Post by Allezcat »

Has anyone experienced shaft pitting under the Tides lip seals causing leaks? I now have this on both shafts and am considering replacing both Tides seals and moving them slightly so they ride on a smooth part of the shaft. The seals have performed admirably until now.
Catrina
1st mate
1st mate
Posts: 31
Joined: Sun May 09, 2004 1:58 pm
Location: Erie Canal

Re: Propshaft pitting

Post by Catrina »

Yes I did.

Had to replace the shafts and new seals. Gregg at Stuart Yachts indicated that it was caused by lack of oxygen in the water around the shafts if the boat sits in the water over long periods of time "without the shafts turning and water flow" which mine did. Turns out that stainless steel requires oxygen to work. Just Google - Crevice Corrosion on Stainless Steel Propeller Shafts.

Now I make sure they get turned every few weeks.

Good Luck,

Mark
Catrina - MV34 Hull # 55 - 110HP - 4 Blade props
User avatar
thinwater
admiral
admiral
Posts: 1110
Joined: Mon Sep 22, 2008 8:08 am
Contact:

Re: Propshaft pitting

Post by thinwater »

What sort of anodes are you using?

The absence of oxygen does not immediately mean that stainless will be subject to pitting. It is also generally required that there is a galvanic mechanism in place. Often, this is simply passive SS nearby. However, effective anodes can reduce the problem.

I this case I would suggest taking a look at aluminum anodes. They offer slightly higher potential and are lot prone to deactivation by oxide coating. They are also cheaper and last longer.
Writing full time since 2014.
"Rigging Modern Anchors,"Seaworthy Press, https://www.amazon.com/Rigging-Modern-A ... 1948494078
Book Store. http://sail-delmarva.blogspot.com/2017/ ... store.html
Post Reply