Rear side slide windows' pull/latch replacement
-
- skipper
- Posts: 77
- Joined: Fri Feb 08, 2019 3:59 pm
Rear side slide windows' pull/latch replacement
Has anyone had experience replacing the black rear side slide windows pull/latch? The previous owner purchased two slide window combination latch and widow pulls, but it looks like the install requires removing the window. Has anyone replaced the latches before or removed the glass? If so, I would like to know if there is a trick to removing the glass or otherwise replacing the latch.
Re: Rear side slide windows' pull/latch replacement
Here ya go...
Replacing Salon Sliding Window Latch Procedure
1. Remove 4’ black plastic groove track at top (center) of both window frames… gently.
2. Remove exterior window first - Push up and pull out at bottom… gently.
3. Remove interior window - Push up and pull out at bottom… gently.
4. Remove broken latch.
5. Drill hole in new latch for PIN (⅛”?) — carefully!
6. Slide new latch into slot; position over PIN hole.
7. Install PIN - use hammer (lightly).
8. CLEAN window grooves… if needed, gently pull out entire plastic groove track and clean. Reinstall when clean.
9. Reinstall interior window first - Slide up into frame groove and push in at bottom… gently.
10. Reinstall 4’ black strip of “liner” at top of interior window frame…
11. Reinstall exterior window - Slide up into frame groove and push in at bottom… gently.
12. Reinstall 4’ black strip of “liner” at top of exterior window frame.
Replacing Salon Sliding Window Latch Procedure
1. Remove 4’ black plastic groove track at top (center) of both window frames… gently.
2. Remove exterior window first - Push up and pull out at bottom… gently.
3. Remove interior window - Push up and pull out at bottom… gently.
4. Remove broken latch.
5. Drill hole in new latch for PIN (⅛”?) — carefully!
6. Slide new latch into slot; position over PIN hole.
7. Install PIN - use hammer (lightly).
8. CLEAN window grooves… if needed, gently pull out entire plastic groove track and clean. Reinstall when clean.
9. Reinstall interior window first - Slide up into frame groove and push in at bottom… gently.
10. Reinstall 4’ black strip of “liner” at top of interior window frame…
11. Reinstall exterior window - Slide up into frame groove and push in at bottom… gently.
12. Reinstall 4’ black strip of “liner” at top of exterior window frame.
Mac Carter
2006 34' PDQ PowerCat "All Heart"; MV 98; twin 100 HP Yanmars
Home Port: Bellingham WA 98229
2006 34' PDQ PowerCat "All Heart"; MV 98; twin 100 HP Yanmars
Home Port: Bellingham WA 98229
-
- skipper
- Posts: 77
- Joined: Fri Feb 08, 2019 3:59 pm
Re: Rear side slide windows' pull/latch replacement
Thank you so much. That will be a big help.