Repowering with 4jh110 motors

Post here if you want to discuss a topic specific to the MV/32, MV/34, and MV/41.
Post Reply
island time
deckhand
deckhand
Posts: 21
Joined: Mon Jan 04, 2016 5:58 am
Location: Cape Coral, Fl.

Repowering with 4jh110 motors

Post by island time »

I am considering repowering from the 75hp motors to the new 4JH110 hp motors, any thoughts or info would be greatly appreciated, prop size , specs . or any other info
Vinnie L 2002 PDQ Powercat 34 Hull #18
Speedo
deckhand
deckhand
Posts: 15
Joined: Thu Sep 07, 2017 4:44 pm

Re: Repowering with 4jh110 motors

Post by Speedo »

Hi, sorry for the late reply, but the last few months have been rather hectic. I haven’t been on the forum for months.
So here we go, I purchased a 2006 with upgraded 110’s. They are the Yanmar electronic models. They were installed by the previous owner so I don’t have exact cost numbers, but it was very steep. (Mostly labor costs for installation)
Performance is very good. As a new owner It’s hard for me to compare. They run smoothly and are efficient. I normally cruise at 13.5 knots and burn under 5 gph. WOT is 19.5 knots while burning 11.4 GPH.
Hope this was not too late to help.
Good luck with your choice,
Jim Earl
2006 PDQ
Well Done 38
Yanmar 110’s
Post Reply