Transom edge guard

Discussions regarding electronics, gear and other equipment of maintenance issues that ARE NOT SPECIFIC to a certain PDQ model yacht
Post Reply
Marc Gershel
admiral
admiral
Posts: 204
Joined: Sat May 08, 2004 1:58 am
Location: Philadelphia.Pa 36021

Transom edge guard

Post by Marc Gershel »

Hi, I've noticed on some PDQs, what appears to be, a vinyl or rubber edge guard on the outer edge of the transom step. Was that a factory option, or can that be purchased anywhere? I tried searching for it without any luck. My edges have taken a beating over the years.
Thanks, Marc
doubledutch
admiral
admiral
Posts: 169
Joined: Fri May 07, 2004 2:23 pm
Location: Ontario (32043)

Re: Transom edge guard

Post by doubledutch »

You may find it at www.spaenaur.com
Marc Gershel
admiral
admiral
Posts: 204
Joined: Sat May 08, 2004 1:58 am
Location: Philadelphia.Pa 36021

Re: Transom edge guard

Post by Marc Gershel »

Thanks for the suggestion, but no luck.
Marc
doubledutch wrote:You may find it at http://www.spaenaur.com
carib sailor
1st mate
1st mate
Posts: 48
Joined: Wed Jan 02, 2008 12:26 pm

Re: Transom edge guard

Post by carib sailor »

The transom edge guard for the 36 was molded out of fiberglass and gel-coated, then attached to the transoms with marine adhesive.
Marc Gershel
admiral
admiral
Posts: 204
Joined: Sat May 08, 2004 1:58 am
Location: Philadelphia.Pa 36021

Re: Transom edge guard

Post by Marc Gershel »

OOOooohhh, That 'splains why I can't find it. Have to try a Plan B now.
Thanks, Marc
James Power
admiral
admiral
Posts: 286
Joined: Tue Apr 01, 2008 3:30 pm
Location: Georgian Bay

Re: Transom edge guard

Post by James Power »

PDQ used moulded fiberglass trim made in house on the 36, and a flexable vinyl trim on the 32's, 34's and 44's. There are a few people looking for the vinyl trim, so I will see if I can find the supplier.

James
Marc Gershel
admiral
admiral
Posts: 204
Joined: Sat May 08, 2004 1:58 am
Location: Philadelphia.Pa 36021

Re: Transom edge guard

Post by Marc Gershel »

Thanks James.
Post Reply