Archway on back (effect on speed)

Discussions regarding electronics, gear and other equipment of maintenance issues that ARE NOT SPECIFIC to a certain PDQ model yacht
Post Reply
lauraj
1st mate
1st mate
Posts: 45
Joined: Mon Jul 29, 2013 9:47 am
Location: On the hard in Ft. Pierce FL hull 34008
Contact:

Archway on back (effect on speed)

Post by lauraj »

wasn't sure if this qualified as gear or equipment.
We are wanting to add an archway to a 1990 32'.
because of the flat backs, mounting the outer leg on the steps doesn't seem to work and we don't want to lose the distance between the hulls by mounting internal of the hulls. which would leave mounting it flat on the top of the back hulls (next to the rudder chamber)
we are concerned about putting that much weight that far back and what it will do to speed and handling.
anyone else researched/done this? comments/suggestions?
User avatar
thinwater
admiral
admiral
Posts: 1110
Joined: Mon Sep 22, 2008 8:08 am
Contact:

Re: Archway on back (effect on speed)

Post by thinwater »

Effect on speed. Determine how much weight you are talking about, add that for a test, and go motor. I'm guessing about 0.2 knots, based on some weight and lengthening experiments. How over loaded the boat is before will also matter. There is also windage and weatherliness to consider; the boat will go to windward less well. Burry the transoms and you can make a pig.

Handling. I doubt it will be noticable. Tacking and docking may be affectedba little.

Personally , I think it crowds the back, makes carrying bikes and kayaks harder, makes loading the dingy harder, makes fishing awkward, and adds little. Just depends on prioreties. I would add solar other places first.
Writing full time since 2014.
"Rigging Modern Anchors,"Seaworthy Press, https://www.amazon.com/Rigging-Modern-A ... 1948494078
Book Store. http://sail-delmarva.blogspot.com/2017/ ... store.html
Marc Gershel
admiral
admiral
Posts: 204
Joined: Sat May 08, 2004 1:58 am
Location: Philadelphia.Pa 36021

Re: Archway on back (effect on speed)

Post by Marc Gershel »

Was the 32' built in 1990?
amytom
admiral
admiral
Posts: 694
Joined: Fri Oct 05, 2007 10:57 am
Location: Orlando, FL S/V DogHouse PDQ32009

Re: Archway on back (effect on speed)

Post by amytom »

1990? Flat backs?

Could your boat be an early 34'? Cabins forward or aft?
User avatar
thinwater
admiral
admiral
Posts: 1110
Joined: Mon Sep 22, 2008 8:08 am
Contact:

Re: Archway on back (effect on speed)

Post by thinwater »

In that case, I'd add 4-6' and some steps.
Writing full time since 2014.
"Rigging Modern Anchors,"Seaworthy Press, https://www.amazon.com/Rigging-Modern-A ... 1948494078
Book Store. http://sail-delmarva.blogspot.com/2017/ ... store.html
lauraj
1st mate
1st mate
Posts: 45
Joined: Mon Jul 29, 2013 9:47 am
Location: On the hard in Ft. Pierce FL hull 34008
Contact:

Re: Archway on back (effect on speed)

Post by lauraj »

Yes, the year and length have been a matter of much debate.
the hull number specifies 1990 (#8) it didn't rough measure at 34' and the manual on the boat is for a 36'.
Mack sails said they didn't make the 34' in a sail model that year.

But Yes, very flat steps. anyone know where the extension molds went?
User avatar
thinwater
admiral
admiral
Posts: 1110
Joined: Mon Sep 22, 2008 8:08 am
Contact:

Re: Archway on back (effect on speed)

Post by thinwater »

I think you can make better molds with sheet metal. This is a common and well proven method. It is certainly faster, as the transom extensions are molded right onto the boat.

http://sail-delmarva.blogspot.com/2013/ ... ocess.html

http://sail-delmarva.blogspot.com/2013/ ... nsoms.html

The mold construction, installation, and hull lamination were finished in one day. A second day finished the step construction and trimming, and a partial day was spend fairing for paint. Hard days in the middle of the summer, but the benefits in ease of boarding alone were worth it.

Though I only built one step, adding steps all the way up, using 1/4" pre-laminated FRP is the easy part, more like carpentry and fancy glass work. Just glass in strips for stringers, glass the steps to them, and fair with nice fillets.

Done thoughtfully, I think it would bring considerable resale value to a PDQ 32/34/36. It might even make sense to go beyond 36', but that would require a good look at the lines. You want to follow the existing curves and you do NOT want to end with the transom more than ~ 4-6 inches out of the water. Remember, when under power, and even more so when sailing hard to windward, the hull drops 6" into its wake. At rest my new transoms are 4" out, but they are awash when motoring hard or sailing in a breeze. I could have gone longer, but I thought it might look odd, and I am very happy with the result.
Writing full time since 2014.
"Rigging Modern Anchors,"Seaworthy Press, https://www.amazon.com/Rigging-Modern-A ... 1948494078
Book Store. http://sail-delmarva.blogspot.com/2017/ ... store.html
lauraj
1st mate
1st mate
Posts: 45
Joined: Mon Jul 29, 2013 9:47 am
Location: On the hard in Ft. Pierce FL hull 34008
Contact:

Re: Archway on back (effect on speed)

Post by lauraj »

Sounds great. Want to come down to FL for a few days in December and GC the job? :P
Seriously, thanks for the great info....and you're welcome to join us.
User avatar
thinwater
admiral
admiral
Posts: 1110
Joined: Mon Sep 22, 2008 8:08 am
Contact:

Re: Archway on back (effect on speed)

Post by thinwater »

I'm going to Puerto Rico Sunday, for the week. They don't make me work on fiberglass. :lol:
Writing full time since 2014.
"Rigging Modern Anchors,"Seaworthy Press, https://www.amazon.com/Rigging-Modern-A ... 1948494078
Book Store. http://sail-delmarva.blogspot.com/2017/ ... store.html
User avatar
SecondWind
admiral
admiral
Posts: 404
Joined: Sat May 08, 2004 8:57 am
Location: Punta Gorda, Fl (33950)
Contact:

Re: Archway on back (effect on speed)

Post by SecondWind »

If you bought the boat from Karen & Al Keyser and it was called CATITUDE, then you have hull # 34008, which was the 34' predecessor to the 36. The molded steps were added to allow a dog to come aboard the boat.
Terry Green
s/v Second Wind
36040
Post Reply