Starter relay/solenoid

Post here if you want to discuss a topic specific to the MV/32, MV/34, and MV/41.
Post Reply
gallf1
deckhand
deckhand
Posts: 22
Joined: Sun Jun 11, 2023 8:41 am
Location: Palm Coast, FL

Starter relay/solenoid

Post by gallf1 »

As a preventative maintenance item, I was looking at removing the original Yanmar solenoids (mounted down low and adjacent to the starter) as I had heard that when they fail it is always at the worst time and they are hard to get at.

I had to remove the alternator and use several sources of lighting from different angles and a small mirror to see where they are mounted. Using a 10mm socket and wrench, I was able to remove them. It was a good thing I did as both engines had rusted solenoids with the connection terminals being extremely corroded. I took one apart and the internal contact points were also corroded so I think I caught them in time!

While I could have used a small low current solid state relay, I used a tried and true Cole Hersee solenoid and mounted it to the inside of the hull in a high and dry location close to the engine. Since the solenoid is not attached to the engine, you have to provide a ground wire to the engine block but other than that it was "relatively" easy.
Attachments
Solenoid.jpg
IMG_4403.jpg
IMG_4402.jpg
IMG_4401.jpg
Last edited by gallf1 on Thu Jan 16, 2025 1:48 pm, edited 1 time in total.
"Sea Gypsy"
Felix & Susan Gallo
2006 MV 34, Hull #82
75hp Yanmar
3-blade, 16 x 13
User avatar
AMCarter3
admiral
admiral
Posts: 463
Joined: Thu Apr 21, 2016 8:32 am
Location: Bellingham, WA
Contact:

Re: Starter relay/solenoid

Post by AMCarter3 »

Nicely done.
Mac Carter
2006 34' PDQ PowerCat "All Heart"; MV 98; twin 100 HP Yanmars
Home Port: Bellingham WA 98229
Post Reply