I've seen this topic in the past, but not specific to my question. Changing the lower case transmission oil without pulling the engines into the cockpit. The suggestions about running up on a bar and waiting for low tide works great, unless you're in an area with 1.5' tidal range in Florida. Does the engine need to be directly vertical, or on an angle, as long as the lower drain is lower than the higher?
Bob Gruber
Island Time 32
lower case transmission oil change
-
- admiral
- Posts: 694
- Joined: Fri Oct 05, 2007 10:57 am
- Location: Orlando, FL S/V DogHouse PDQ32009
Re: lower case transmission oil change
To get all the oil out it needs to be close to vertical. A partial change is still better than nothing though. The big thing is to check the oil that comes out, any water or grit and you really need to pull it and have it looked at.
Re: lower case transmission oil change
You could pull the lower unit of from a dinghy, change the lower unit oil then reinstall.
-
- admiral
- Posts: 204
- Joined: Sat May 08, 2004 1:58 am
- Location: Philadelphia.Pa 36021
Re: lower case transmission oil change
WOW! Have you actually done this? I give you a lot of credit.Smj wrote:You could pull the lower unit of from a dinghy, change the lower unit oil then reinstall.
Marc
Re: lower case transmission oil change
I haven't but my friend on his Seawind 1000 changes his lower unit oil and impeller this way. I'm guessing the hardest part would be disconnecting the shift rod.
-
- admiral
- Posts: 694
- Joined: Fri Oct 05, 2007 10:57 am
- Location: Orlando, FL S/V DogHouse PDQ32009
Re: lower case transmission oil change
Disconnecting the shift rod is easy. The hard part would be lining it back up swimming in a current.
Re: lower case transmission oil change
It can be easy to disconnect the shift rod or it can take quite some time with corrosionx and gently working it loose. I've had it go both ways.
Re: lower case transmission oil change
Thanks for the suggestions. I would think pulling the engines, and making the change in the cockpit would be easier than pulling the lower units. It's just time consuming.
My question really asks if the cavity that holds the lower unit oil is shaped more like an oval or a rectangle? If more like an oval, the drainage would be more complete.
Bob Gruber
Island Time 32
My question really asks if the cavity that holds the lower unit oil is shaped more like an oval or a rectangle? If more like an oval, the drainage would be more complete.
Bob Gruber
Island Time 32
-
- admiral
- Posts: 694
- Joined: Fri Oct 05, 2007 10:57 am
- Location: Orlando, FL S/V DogHouse PDQ32009
Re: lower case transmission oil change
The cavity is oval shaped. It's just the housing for the bearings that is filled up.