Genset exhaust hose angle
Posted: Wed Feb 16, 2022 11:35 am
In studying the setup of my Northern Lights genset (planning some maintenance this summer), I wonder how to improve the angle of the exhaust hose. From the exhaust elbow to the lift muffler, the hose should be at a constant 1/2”+ per foot angle downward. However, due to the exhaust elbow discharging “the wrong way” (to the aft), the exhaust hose is about 2’ longer than it could be & tends to sag causing a bit of up & down path for the exhaust water.
I’ve thought of a few fixes:
- Replacing the exhaust elbow with a new SS one & have an elbow welded to it (to eliminate the extra hose length & make a better/constant angle for the shorter exhaust hose).
- Make some sort of framework to fasten the hose to (eliminating the ups & downs).
Any thoughts?
I’ve thought of a few fixes:
- Replacing the exhaust elbow with a new SS one & have an elbow welded to it (to eliminate the extra hose length & make a better/constant angle for the shorter exhaust hose).
- Make some sort of framework to fasten the hose to (eliminating the ups & downs).
Any thoughts?