Kobelt/Felstad Control Cables
Posted: Thu Oct 06, 2022 2:51 pm
Does anyone know the lengths of the control cables of the 2002 year 34? In that year the upper station was biased toward the starboard side of the boat almost to the edge of the fly bridge.
I think it will be easier to attach replacement cables to the old to rerun the new cables versus remove measure and replace. The most critical on a replacement basis for my boat are the 4 upper/remote to the primary control. These are pull-pull cables and I'm guessing in the 23-26 foot range. It seems the port engine cables might be a foot shorter than the starboard side.
Also if anyone has done this what brand and type of cable did you use other than the Felstadt. I live in San Diego and Kobelt has a dealer in the area.
I should probably have replaced mine sooner than now. I had a threaded end of the upper cable break in a crowed anchorage. My boat may run a straight course when there is flow at 5+ knots over the rudder but at zero speed it was exciting.
Thanks
I think it will be easier to attach replacement cables to the old to rerun the new cables versus remove measure and replace. The most critical on a replacement basis for my boat are the 4 upper/remote to the primary control. These are pull-pull cables and I'm guessing in the 23-26 foot range. It seems the port engine cables might be a foot shorter than the starboard side.
Also if anyone has done this what brand and type of cable did you use other than the Felstadt. I live in San Diego and Kobelt has a dealer in the area.
I should probably have replaced mine sooner than now. I had a threaded end of the upper cable break in a crowed anchorage. My boat may run a straight course when there is flow at 5+ knots over the rudder but at zero speed it was exciting.
Thanks